Engine management faults have a habit of looking simple and being subtle. A rough idle might be a leaking injector seal, a dirty MAF, a split intake hose or a failing coil — four very different prices. The only way to be fair about it is to measure, and that is what the diagnostic hour is for.
We handle injector and pump work on petrol and diesel engines, EGR and DPF faults, forced-induction problems and the sensor and wiring faults that sit behind most of them. Where a component is genuinely beyond economic repair we will say so, and where cleaning or recalibration will do the job we will try that first.
What is included
- Injector testing, cleaning and replacement
- EGR valve cleaning and replacement
- DPF diagnosis, forced regeneration and replacement advice
- Turbo and boost fault diagnosis
- MAF, MAP, lambda and knock sensor faults
- Fuel pump, filter and pressure fault repairs
What happens, step by step
Read the data
Live values under load tell you what a fault code cannot.
Isolate
Rule out the cheap causes — hoses, wiring, sensors — before quoting expensive parts.
Repair and re-learn
Fit, then perform the relevant adaptations and re-test under load.
Verify
Road test to confirm the fault is gone, not just the light.
Where this happens
All workshop work is carried out at Unit 30, Stevenage Enterprise Centre, SG1 3HH — five minutes from Stevenage town centre and the Old Town, with parking on site. Drop-off is from 07:30 on weekdays. If the car cannot be driven, call 07876 714 517 for recovery.
